MODELING INFILTRATION KINETICS OF LIQUIDS INTO POROUS ALUMINA PREFORMS

Posman Manurung; It Meng Low; Craig Buckley

doi:10.17146/jsmi.2006.7.2.4997

MODELING INFILTRATION KINETICS OF LIQUIDS INTO POROUS ALUMINA PREFORMS

Posman Manurung⁽¹⁾, It Meng Low⁽²⁾, Craig Buckley⁽³⁾,

(1) Materials Research Group, Department of Physics, The University of Lampung Jl. S. Brojonegoro No 1, Bandar Lampung 35145
(2) Materials Research Group, Department of Applied Physics Curtin University of Technology, Perth, WA
(3) Materials Research Group, Department of Applied Physics Curtin University of Technology, Perth, WA

Corresponding Author

Abstract

MODELING INFILTRATION KINETICS OF LIQUIDS INTO POROUS ALUMINA PREFORMS. Alpha-alumina preform was infiltrated with different infiltrant and pressure for studying the infiltration kinetic. Effects of pre-sintering temperature, type of infiltrant, pressure and multiple infiltrations on the rate of infiltration into porous alumina preforms were described. The pore radius of alumina preform is calculated based on the preform water system by using Washburn model. The pore radius from this model, r of 0.0147 μm is good agreement to the average pore radius found by using mercury porosity measurement, r of 0.0170 μm. The pore radius of 0.0147 μm is used to calculate the rate of infiltration, k. The k factors are 64.83 x 10^-5 ms^½ and 27.11 x 10^-5 ms^½ for water and TiCl₃ respectively without involving pressure in the calculation. On the other hand, by using pressure, the k factors are 75.14 x 10^-5 ms^½ and 31.40 x 10^-5 ms^½ for water and TiCl₃ respectively. Other formulas were also included as comparisons. The kinetic of water and titanium trichloride alumina preform system is parabolic in time or linier in square root of time.